Caution: Flammable mixture.
Do not use near fire or flame.
Use with adequate ventilation.

1. Make sure all surfaces are free of oil or grease.

2. Roughen both surfaces to be joined thoroughly and properly. Remove dust.

3. Work Jet Set into fibres with stiff brush. If desired, two applications may be given to leather, about 15 minutes apart.

4. Allow leather to dry 10-15 minutes, longer for other materials. (Adhesion for up to 3 hours for rubber, slightly less for leather.)

5. Hammer surfaces together or place in speedpress for 3 seconds.

Note: Jet Set will thicken with prolonged exposure to air. Thin only with Jet Set® Special Formula Thinner. Other thinners will decrease strength of bond and void guarantee.

Note: If outside temperature is below 10⁰C (50⁰F) when delivered, store overnight in warm room before use.

Prior to use, the cans (with lids firmly closed) should be gently turned upside down and back to mix the adhesive thoroughly.

Adhesive can be transferred into smaller glue containers available from Mason Grogan, which help extend the life of the adhesive and reduce fumes.
Available container sizes:
0.4L
0.9L
1.5L